Specifications; Programming Times Vs Code Size For The Gang Programmer; Msp-Gang430 Hardware Specifications - Texas Instruments MSP430 User Manual

Specifications

5.1 Specifications
The specifications for the MSP-GANG430 hardware are shown in
Power supply
Output voltage (V )
CC
Output voltage (VPP)
Signal path length between MSP-GANG430 and each target. If
cables between programmer and targets are longer then 20 cm,
serial resistors of 100 Ω should be inserted on signals TCK and
TMS on the expansion board. TCK is on pin 4, TMS on pin 3 of
the 25-pin Sub-D connector.
Temperature range
Humidity
Dimensions
5.2

Programming Times vs Code Size for the Gang Programmer

T [ms] Ⅹ 210 + T
total
Where
E = 1 if Erase checkbox is selected, 0 otherwise
EC = 1 if Erase Check checkbox is selected, 0 otherwise
P = 1 if Program checkbox is selected, 0 otherwise
V = 1 if Verify checkbox is selected, 0 otherwise
T : VCCT settle time in ms, defined in [User] section of GANG430.ini (e.g., VCCTSettleTime = 100)
S
size : Flash memory size in KBytes of the selected device
mem
size : Code size in KBytes
code
The following example is for MSP430F149, with all functions selected, T
programmed:
T [ms] = 210 + 100 + 220 + 2 × 7.6 × 60 + 175 × 60 = 11942 = 12 sec
total
The following equation is a simplified formula for all functions selected, T
memory of device programmed:
T [ms] Ⅹ 530 + 190 × size
total
NOTE: Using SpyBiWire mode requires approximately 3 seconds to program 2 KByte. As devices
are programmed consecutively, the total time for eight devices is 24 seconds.
56
Hardware
Table 5-1. MSP-GANG430 Hardware Specifications
+ E × 220 + (EC + V) × 7.6 × size
S
code
Copyright © 2003–2010, Texas Instruments Incorporated
Table 5-1.
9 V to 15 V dc, 300 mA minimum
1.8 V to 3.6 V ± 100 mV dc, 150 mA maximum
6.5 V ± 400 mV dc, 150 mA maximum
<60 cm
10°C to 45°C (50°F to 113°F)
40% to 70%
150 mm (W) × 30 mm (H) × 82 mm (D)
+ P × 175 × size
mem code
= 100 ms, and full memory
S
= 100 ms, and nearly the full
S
SLAU101O – March 2003 – Revised May 2010
www.ti.com