Preface - Texas Instruments MSP430 User Manual

About This Manual
This user's guide documents the MSP430 gang programmer MSP-GANG430 .
How to Use This Manual
This document contains the following chapters:
• Chapter 1 – Introduction, Installation, and Setup
• Chapter 2 – Operation
• Chapter 3 – Firmware
• Chapter 4 – Dynamic Link Library GANG430.DLL
• Chapter 5 – Hardware
• Chapter 6 – Schematics
Information About Cautions and Warnings
This book may contain cautions and warnings.
This is an example of a caution statement.
A caution statement describes a situation that could potentially damage your
software or equipment.
This is an example of a warning statement.
A warning statement describes a situation that could potentially
cause harm to you.
The information in a caution or a warning is provided for your protection. Please read each caution and
warning carefully.
If You Need Assistance...
Support for the MSP430 device and the MSP-GANG430 is provided by the Texas Instruments Product
Information Center (PIC). Contact information for the PIC can be found on the Texas Instruments web site
at www.ti.com. Additional device-specific information can be found on the MSP430 web site at
www.ti.com/msp430.
SLAU101O – March 2003 – Revised May 2010
CAUTION
WARNING
Copyright © 2003–2010, Texas Instruments Incorporated
SLAU101O – March 2003 – Revised May 2010
Read This First
Read This First

Preface

7