Installation
Removing the Rainhood
3–6
For indoor installations, the GT100 enclosure has provisions for an exhaust air
duct to be attached, by means of a 355 × 200 mm (14 × 8 in) opening at the top of
the enclosure. The GT100 enclosure rainhood must be removed in order to access
the exhaust opening.
To remove the GT100 Rainhood:
1. Remove the 8 mm nuts (8 total) that attach the rainhood to the top of the
GT100 enclosure.
2. Carefully remove the rainhood.
Figure 3-5 Removing the Rainhood
This manual for use by qualified installers only
8 mm nuts (8 total)
355 × 200 mm (14 × 8 in)
opening
153379