Removing the Pallet and Moving the GT100
c
Moving with a Forklift
153379
CAUTION: Equipment Damage
To move the GT100, use a forklift that has a sufficient lift capacity and a 66 cm fork span.
Use Figure 3-1 to locate the balance point or center of gravity (
Front view
Figure 3-1 Center of Gravity
To move the GT100 using a forklift:
1. Place the forks of the forklift below the unit at the points specified in
Figure 3-2 on page 3–4.
2. Lift the GT100 from beneath.
Be sure to use a forklift with a 66 cm fork span.
3. Remove the shipping pallet from beneath the unit.
4. Once the shipping pallet is removed from the unit, use the same lifting
locations to lift the unit into the place where it may be permanently located.
This manual for use by qualified installers only
Center of Gravity
609mm (24")
850mm (33.5")
Unloading
symbol).
355mm (14")
Side view
3–3