40 Lighting, windscreen wipers and washers ›
Replacing the light bulb
on the headlight again.
After changing the light bulb for the low beam
light
›
Insert the cover in the wheel arch and lock into
place.
After changing the light bulb for the high beam in
the right headlight
›
Reinstall the washer fluid reservoir holder.
›
Insert the container nozzle back into the holder.
Tail light assembly
Loosen and remove the light
Replace light bulbs
Protective caps on the
headlight:
Low beam
A
Main beam
B
›
Remove the associated
protective cap.
›
Press the socket with
the light bulb down-
wards and remove it.
›
Change the bulb in the
socket.
›
Insert the socket with
the new light bulb into
the headlight, so that
the fixing lug
is
A
pointing up.
›
Insert the socket until
it clicks into place.
›
Fit the protective cap
›
Unscrew the screws
.
A
›
Insert the bracket from
the tool kit into the re-
cess in the light.
On the left-hand lamp,
the eyelet of the
bracket must point
downwards, and up-
wards on the right lamp.
›
Remove the lamp with the bracket.
Change bulb - Variant 1 (light with LED light sour-
ces)
›
Insert the bulb holder into the light and snap into
place.
NOTICE
Risk of damage to the electrical system!
Make sure that no cables are pinched when insert-
▶
ing the holder into the light.
Change bulb - Variant 2 (light only with light bulbs)
›
Slightly pull out the
lock
at the plug.
A
›
Press the safety button
and remove the plug.
›
Unlock and remove the
lamp holder
.
A
›
Twist the defective
bulb and remove it
from the holder.
›
Insert a new light bulb
into the socket and se-
cure the light bulb by
turning it in the direc-
tion of
.
›
Check that the plug
A
securely connected.
Change the bulb in the
outer part of the lamp.
›
Turn and remove the
socket with the bulb.