Table of Contents
Advertisement
Lighting, windscreen wipers and washers ›
Deactivate daytime running lights on vehicles with
Infotainment blues or without Infotainment
›
Switch off the ignition.
the lever.
Activate daytime running lights on vehicles with
Infotainment blues or without Infotainment
›
Switch off the ignition.
the lever.
Troubleshooting
Turn signal light defective
flashes faster - turn signal light on the right de-
fective
›
Check the turn signal light on the right.
flashes faster - turn signal light on the left de-
fective
›
Check the turn signal light on the left.
does not flash when the trailer is hitched -
trailer turn signal light defective
›
Check the trailer lighting.
Light bulb or LED bulb is defective
illuminates together with
Information appears in the display regarding
the affected lights.
›
Replace the defective bulb.
›
In case of a defective LED lights, contact a special-
ist garage for help.
The headlights are misted up on the inside
Inside the headlights, moisture may occur. This is not
a defect.
Malfunction of the automatic headlight circuit
›
Clean the windscreen in the area of the rain/light
sensor.
Beam of light in front of the vehicle has shortened
Headlight defective.
›
Pull the lever towards
the steering wheel,
push it downwards and
hold it in this position.
›
Turn on the ignition.
›
As soon as an acoustic
signal sounds, release
›
Pull the lever towards
the steering wheel,
push it upwards and
hold it in this position.
›
Turn on the ignition.
›
As soon as an acoustic
signal sounds, release
COMING HOME, LEAVING HOME exterior lighting
›
Seek the help of a specialist garage.
Driving lights defective
If a message regarding the failed driving lights is dis-
played, the light will work in emergency mode.
›
Drive on, exercising appropriate caution.
›
Seek the help of a specialist garage.
COMING HOME, LEAVING HOME
exterior lighting
Functionality
The COMING HOME function turns on the light after
turning off the ignition and opening the driver's door.
The LEAVING HOME function switches on the light
when unlocking the vehicle with the wireless remote
control.
Operating conditions
✓ Visibility has worsened.
✓ The light switch is in the
Settings
This function is set in the following menu in the Info-
tainment system.
Light Assist high-beam assist system
Functionality
The high beam assist system automatically switches
the high beam on and off.
WARNING
Risk of an accident!
If necessary, manually switch the high beam on or
▶
off.
Operating conditions
✓ The system is activated.
✓ The light switch is in the
✓ The driving speed is higher than 30 km/h (for
some countries, higher than 60 km/h).
✓ The low beam is switched on.
37
position.
position.
Advertisement
Table of Contents
