108 Driver assist systems ›
WARNING
ACC does not respond to stationary objects or to
crossing or oncoming objects.
ACC is intended primarily for use on motorways.
Speed range
ACC allows a speed setting in the range of
30-160 km/h.
If control is started at a speed of less than 30 km/h
on vehicles with an automatic transmission, the
speed is automatically increased to 30 km/h or con-
trolled according to the speed of the vehicle ahead.
Distance level
The distance from the vehicle ahead can be adjusted
in the range from 1 to 3.6 s in five different levels.
Automatic stop and start
A vehicle with an automatic transmission can be de-
celerated to a stop using the ACC and start moving
again. Control is disconnected in case of longer hold-
ing periods.
Overtaking
If your vehicle changes to the fast lane and no vehi-
cle is detected in front, ACC accelerates up to the
set speed.
Status display in the instrument cluster display
- ACC is activated
along with
- Control is active
When the control starts, the set speed is dis-
played.
- ACC does not decelerate sufficiently
›
Depress the brake pedal.
Operation
Operating with the lever
Activate ACC (control inactive)
Adaptive Cruise Control (ACC)
Start or resume control/Increase speed in
steps of 1 km/h (sprung position)
Interrupt control (sprung position)
Deactivate ACC
Increase speed in steps of 10 km/h
Reduce speed in steps of 10 km/h
Set distance level
Start control/Reduce speed in steps of 1
km/h
Starting control with the current speed
›
Tap on
.
Or:
›
If no speed is saved, move the lever to the sprung
position
.
Set distance level
›
Move the
switch to the sprung position
or .
For temporary acceleration
›
Depress the accelerator pedal.
The vehicle accelerates and control is temporarily in-
terrupted. Upon releasing the accelerator, control is
resumed.
Interrupting cruise control
After pressing the brake pedal.
▶
By operating the clutch pedal for a long time.
▶
After an ESC intervention.
▶
After deactivation of the ASR.
▶
Resuming control
›
If a speed is stored, move the lever to the sprung
position
.
The vehicle is controlled at the set speed. The set
speed is shown in the instrument cluster display.
Function restriction
WARNING
Be particularly attentive and alert in the following
▶
situations.
Line
appears in the
A
display, indicating the
change in distance.
›
Use the
switch
to set the desired dis-
tance level.