CR 30-X/CR 30-X
M
Configuration
The digitizer is always dedicated to a single workstation, on which the
identification software as well as the image processing software is running.
The identification data are transmitted from the workstation to the digitizer
via DICOM Ethernet. For more information, refer to the workstation's On-line
Help manuals or contact your local service organization.
Dedicated configuration
For more information, refer also to the CR 30-X/CR 30-Xm System User
Manual, document 2385.
10
Introduction
Caution:
The digitizer must not be connected to any version of the Agfa
TM
ADC QS
or ADC VIPS
digitizer
Control PC
TM
software.
2386G EN 20120110