Table of Contents
Advertisement
5.4
MANUAL START OF MOTOR/PRIMING
This procedure is applicable when you want to manually start the system or prime the pump.
It is possible to manually start the motor by pressing the following sequence of buttons:
Buttons sequence with pump off
The pump remains on until the last button is pressed
x
During manual start-up, the motor rotates at maximum speed and the pressure
control is not activated, therefore the pump reaches its maximum pressure.
x
Ensure there is water inside the pump unit, otherwise the pump seal will be
destroyed.
5.5
MANUAL START/STOP
It is possible to manually stop the pump by pressing the START/STOP button: in this situation the display
shows the writing STOP.
During STOP status the module is not operative unless the anti-lock mode is activated (TAB parameters -
installation parameters 5.3.4). The word "abl" will be displayed if the condition is active.
START/STOP sequence of buttons
x
Press the START/STOP button again to exit the STOP condition.
Last button pressed for 10 seconds
Page 23 of 24
23
23 - GB -
Push STOP button
53
Advertisement
Table of Contents
