Table of Contents
Advertisement
6.3
ALARM TABLE
MESS
DISPLAY
No water alarm -
temporary
A01
No water alarm -
A02
definitive
Pressure
A03
transducer alarm
6.4
ERROR TABLE
MESS
DISPLAY
No event
E00
Generic fault (in
E01
memory)
Temporary external
error
E02
Definitive external
error
E03
Communication
E04
DESCRIPTION
Error
due
to
the
absence of water. This occurs
when water is absent and the
restart
mechanism
has
activated. The will wait before
restarting in order to attempt to
automatically reset the error
This condition occurs when there
is no water and the automatic
restart system has not activated
or
preset
restart
occurred
already
managing to reset the system
functioning.
This alarm condition closes the J3
contact on the power board for
possible external signals (alarm
light, siren, etc.)
This signal occurs when the
control board cannot identify the
transducer pressure signal.
DESCRIPTION
The error log appears when no
errors have been signalled
This error occurs in the presence
of:
x
Internal module error
x
Overheating of the power
module
x
Pump failure
An external error occurs when
there is a problem with the power
module. The module will not be
operative during an EXTERNAL
ERROR.
The
definitive
external
condition is indicated after the
temporary
error
condition
repeated 5 times.
This error condition occurs when
Page 25 of 26
25
25 - GB -
temporary
Check the water level in the first
tank or the aqueduct pressure.
Wait
for
been
attempted restart or press the
button START/STOP for a manual
restart.
attempts
Check the water level in the first
without
tank or the aqueduct pressure.
Press the button START/STOP to
manually restart the system.
Check the pressure transducer is
correctly connected.
If the error occurs again, contact
your nearest assistance centre.
-
Press the START/STOP button to
attempt to exit this condition. In
case of a persistent error, contact
technical support.
In this case, the module will
attempt
to
functioning after 5 minutes and
will repeat this procedure up to
five times.
Press the START/STOP button to
attempt to exit these conditions.
Please contact technical support
of the error persists.
error
Press the START/STOP button to
attempt to exit this condition.
is
Please contact technical support
of the error persists.
Cut the power off and wait until
ACTION
the
programmed
ACTION
restart
normal
55
Advertisement
Table of Contents
