Inspection Of Governor System; Disassembly And Reassembly Of Governor Levers - Mitsubishi L3E Service Manual

ENGINE MAIN PARTS
Check shaft
for flaws.
Figure 53 Check governor system
Expansion
plug
Gear case
Figure 54 Reassembling governor shaft
Service Manual Mitsubishi L-Series diesel engines
Version 08/2004
Check springs
for fatigue.
Check sliding
sleeve joint for
wear and damage.
Protrusion
approx. 2 mm
[0.0787 in.]
Grooved pin
A
Section A-A
A
GEAR CASE AND OIL PUMP

12.6 Inspection of governor system

Check the governor system in the gear case. If any
parts are found defective, repair or replace them.
12.7 Disassembly and reassembly
of governor levers
12.7.1 Disassembling shaft
1. Remove the expansion plug, paying attention not
to scratch the gear case.
2. Pull out the grooved pin.
12.7.2 Reassembling Shaft
1. Reassemble the shaft in the reverse sequence of
disassembly.
2. After reassembling the shaft, press-fit the
expansion plug into the shaft hole in the gear case.
ENGLISH 57 / 155