IBM RS/60000 Series Site And Hardware Planning Information page 208

3. Plan for installing four eyebolts positioned to match the dimensions given in the following illustrations.
24 in REF
610 mm REF
(8) 49.3 mm
Eyebolt
4. Install the eyebolts to the floor.
To install the frame, do the following:
Attention: It is the service representative's responsibility to complete the following steps.
1. Before starting the installation, check all cable openings in the floor panel and location of the rubber
bushing holes so that they match the dimensions given in the illustrations on 190 and 190.
2. Power off the system and make sure all cables and connectors are disconnected and are not
dangling around the frame. The frame should be free to roll.
190
Site and Hardware Planning Information
64.6 mm
(4x) 450 mm REF
654.8 mm
64.6 mm
24 Inch Floor Tile Layout
654.8 mm
64.6 mm
600 mm (23.6 Inch Floor) Tile Layout
(8) x 49.3 mm
Eyebolts
654.8 mm
(4) Opening for Cables
2440 mm REF
96 in REF
(4X) Opening for Cables
64.6 mm
600 mm REF
(4X) 450 mm REF
654.8 mm
23.6 in REF