IBM RS/60000 Series Site And Hardware Planning Information page 128

1. Be sure the rack is in the correct location.
2. Place the mounting plates (item 1 in illustration on page 110), front and rear, in the approximate
mounting position under the system rack.
3. To align the mounting plates to the system rack, do the following:
a. Place the four rack-mounting bolts (item 6 in illustration on page 110) through the plate assembly
holes at the bottom of the rack. Install the bushings and washers (item 4 and 5 in illustration on
page 110) to ensure bolt positioning.
b. Position the mounting plates (item 1 in illustration on page 110) under the four rack-mounting
bolts (item 6 in illustration on page 110) so that the mounting bolts are centered directly over the
tapped holes.
c. Turn the rack-mounting bolts (item 6 in illustration on page 110) three or four rotations into the
tapped holes.
110
Site and Hardware Planning Information