IBM RS/60000 Series Site And Hardware Planning Information page 126

11P4758 Frame tie-down Kit (Long - Raised Floor) (RPQ 8A1186)
Item
Illustration on page 114.
Item 3 in illustration on page 109.
Item 5 in illustration on page 109.
Item 8 in illustration on page 109.
Item 6 in illustration on page 109.
Item 2 in illustration on page 109.
Item 7 in illustration 109.
Item 1 in illustration on page 109.
Item 9 in illustration on page 109.
Item 10 in illustration on page 109.
Mounting Internal Rack Components: To mount the internal rack components, do the following:
Attention: This procedure is performed by the service representative.
1. Using four M-8 (20 mm) screws (item 1 in illustration on page 109), install the top shipping bar (item
2 in illustration on page 109) at EIA unit location 32.
2. Using four M-8 screws (item 1 in illustration on page 109), install the bottom shipping bar (item 3 in
illustration on page 109) at EIA unit location 18.
3. Repeat steps 1 and 2 to install shipping bars in the rear of the rack.
4. Attach the front top hinge (item 5 in illustration on page 109) on the vertical rail (located
approximately at EIA unit 29-30 on the vertical rail) with two 25 mm screws (item 9 in illustration on
page 109) and two washers (item 10 in illustration on page 109).
5. Attach the front bottom hinge (item 5 in illustration on page 109) on the vertical rail (located
approximately on EIA unit 6-7 on the vertical rail) with two 25 mm screws (item 9 in illustration on
page 109) and two washers (item 10 in illustration on page 109).
6. Repeat steps 4 and 5 to install the hinges on the rear rail.
7. Attach the latch plate (item 8 in illustration on page 109) with two M-8 (20 mm) screws (item 1 in
illustration on page 109).
8. Repeat step 7 to attach the latch plate in the rear of the rack.
9. Attach the triangular braces (item 6 in illustration on page 109) in both the front and rear of the rack.
10. Install the latch bolts (item 7 in illustration on page 109).
108
Site and Hardware Planning Information
Part Number Qty
44P0674 4
11P3527 2
11P3529 4
11P3530 2
11P3531 2
11P3532 2
76X4687 2
1624804 20
1621546 8
1622307 8
Description
Turnbuckle Assembly (long)
Shipping bar (lower)
Hinge plate
Latch plate
EQ support
Shipping bar (upper)
Latch bolt
Screw (hex flange, 20mm, long)
Screw (hex, 25mm, long, hinge)
Washer (M8, hinge)