Stihl MS 650 Manual page 74

: Pull the heating element off the
studs.
All machines
1
: Pull the fuel hose (1) off the
carburetor.
: Remove the carburetor.
Reassemble in the reverse
sequence.
MS 650, MS 660
1
: Before fitting the carburetor,
check that the sleeve (1) and
washer (2) are in place.
2
: When pushing the carburetor into
position, check that the impulse
hose (1) is correctly seated.
: Connect the fuel hose (2).
: Squeeze the throttle trigger and
hook the rod (2) to the throttle
shaft (1).
2
: Fit the grommet so that the tabs
(1) engage behind the inside of
the housing.
– On machines with carburetor
heating, make sure that wiring is
properly positioned – b 15.2
1
1
2
73