Stihl MS 650 Manual page 46

2
: Screw threaded sleeve (2) to
thread (1) of crankshaft stub.
: Hold the spindle steady and
rotate the service tool counter-
clockwise until the drilled plate
butts against the crankcase.
: Turn the spindle clockwise until
the crankshaft locates against
the ball bearing.
The connecting rod must point
toward the cylinder flange while the
crankshaft is being installed.
MS 650, MS 660
1
: Hold the crankshaft steady,
release the spindle counter-
clockwise and then unscrew the
service tool, also counter-
clockwise.
1
: Place new gasket (arrow) on the
flywheel side of the crankcase.
: The gasket is held in position by
the pins (1).
– Fit bar mounting studs at clutch
side – b 5.7
1
– Lubricate straight stub of
crankshaft (arrow) with oil.
– Fit crankshaft stub in the ball
bearing.
: To prevent the crankcase halves
and gasket twisting, fit M5x72
screws (arrows) in two crankcase
holes and tighten them down as
far as stop.
1
1
45