Segment; Starter Rope Guide Bushing - Stihl MS 650 Manual

: The rewind spring is correctly
tensioned when the starter grip
sits firmly in the rope guide
bushing (arrow) without drooping
to one side. If this is not the case,
tension the spring by one
additional turn.
When the starter rope is fully
extended, it must still be possible to
rotate the rope rotor at least another
half turn before maximum spring
tension is reached. If this is not the
case, pull the rope out, hold the
rope rotor steady and take off one
turn of the rope.
Do not overtension the rewind
spring as this will cause it to
break.
– Install the fan housing with
rewind starter – b 8.2
MS 650, MS 660
8.7

Segment

1
: Take out the screws (arrows).
: Pull out the segment (1) upwards.
Installing
: Engage tabs (1) in the slots
(arrows).
Reassemble all other parts in the
reverse sequence.
8.8 Starter Rope Guide
Bushing
Wear on the guide bushing is
accelerated by the starter rope
being pulled sideways. The wall of
the bushing eventually wears
through and the bushing becomes
loose.
– Remove the fan housing with
rewind starter –
b 8.2
– Remove the rope rotor – b 8.4
– Use a suitable tool to pry the
damaged bushing out of the fan
housing.
– Place the new bushing in the fan
housing.
1
: Insert the screw spindle (1) of the
installing tool 0000 890 2201
through the bushing from inside
the fan housing.
61