Star Trac Pro S, Pro, Pro Elite Pro STM Treadmill Owner's Manual page 52

Lowest
Item Value
ENTERTAIN- -
MENT
RAIL STOP -
10 REV 22.0
CNT/REV 31
MIN PWM 2
1/2 MX 25
MAX PWM 86
ACCEL TIME 25
DECEL TIME 20
DATE 1.00
NO RAIL 0
STOP
KEY DOWN 0
SPEED CHG 0
ELEV STALL 0
ELEV RANGE 0
ELEV LOST 0
NO MOTOR 0
NO SENSOR 0
ELEV ZERO 175
ELEV MAX 25
LAST DECK 0
LAST BELT 0
LAST MOTOR 0
MASTER PIN 0000
50
Default Highest
Value Value Meaning
OFF - ON=Entertainment enabled.
OFF=Entertainment disabled.
OFF - ON=Enables hardware stop for European units.
OFF=Disables hardware stop for European units.
30.7 74.0 Inches of running belt travel for 10 flywheel revolutions, always measured in
inches. Nominal values are:
1.6" pulley: 27.5
1.7" pulley: 29.1
1.8" pulley: 30.7
2.1" pulley: 35.8
31 125 Number of counts for each motor shaft revolution. Values are:
RPM sensor at flywheel notches: 31
RPM sensor at motor shaft optical disk: 125
30 55 Pulse duty cycle to obtain the selected MN SPD. Divide MN PWM by 512 to
get % duty cycle.
130 170 Pulse duty cycle to obtain 1/2 maximum speed. Divide 1/2 MX by 512 to get %
duty cycle.
230 255 Pulse duty cycle to obtain the selected MX Spd. Divide MX PWM by 512 to get
% duty cycle.
25 60 Time, in seconds, to reach maxmium speed from 0 mph (0 km/hr).
20 60 Time, in seconds, to reach 0 mph (0 km/hr) from maximum speed.
1.98 12.99 Treadmill manufacture date.
0 255 Number of times Hand Rail Stop switch was down or disconnected on power-
up since last reset.
0 255 Number of times key other than 5 or 8 was down on power-up since last reset.
0 255 Number of times speed changed suddenly more than 2 mph (UNITS=English)
or 2 km/hr (UNITS=Metric) since last reset.
0 255 Number of times elevation failed to change (stalled) since last reset.
0 255 Number of times elevation was out of range (not between 0% and 15%) at
power-up since last reset.
0 255 After pressing S
went beyond 0% to 15%, since last reset.
0 255 Number of times the motor could not verify a load since last reset.
0 255 Number of time the sensor was inoperable since las reset.
240 242 Representation of voltage to elevation motor to obtain 0% elevation. Multiply
ELEV ZERO by 0.019608 to get actual voltage.
57 170 Representation of voltage to elevation motor to obtain 15% (maximum) eleva-
tion (incline). Multiply ELEV MAX by 0.019608 to get actual voltage.
120 volt treadmill = 57
230 volt treadmill = 80
0 65,535 Number of miles (UNITS=English), or km (UNITS=Metric) since the running
deck was last serviced or replaced.
0 65,535 Number of miles (UNITS=English) or km (UNITS=Metric) since the running
belt was last replaced.
0 65,535 Number of miles (UNITS=English), or km (UNITS=Metric) since the motor
brushes were last serviced or replaced.
4321 9999 Master Personal Identification Number (PIN) for Personal Trainer.
STAR TRAC PRO S / PRO / PRO ELITE TREADMILL O
and reaching 0% reset, the number of times elevation
TART
' M
WNER S ANUAL