012-268 Booklet Rear Stapler Fail; 012-269 Booklet Sub-Cpu Communications Fail - Xerox WorkCentre 5222 Service Manual

012-268 Booklet Rear Stapler Fail

BSD-ON:12.27
Booklet Stapler Assembly (Rear), cannot clinch properly; Booklet Rear Staple Home Switch
detected not to turn on (return to Home position could not be completed) within designated
time period after starting reverse motion.
Procedure
Execute Component Control[012-026 Rear Staple Motor (FWD) and 012-027 Rear Staple
Motor (REV)] alternately. The motor energizes.
Y N
Check the connections of P/J8895,
J8995 are connected correctly.
Y N
Connect P/J8895, P/J8893 and P/J8995.
Check the wire between J8895 and J8995 for an open circuit or a short circuit (BSD
12.27). The wire between J8895 and J8995 is conducting without an open circuit or
a short circuit.
Y N
Repair the open circuit or short circuit.
Measure the voltage between the Booklet PWB of each P8995-8/9/10/11 (+) and GND (-)
(BSD 12.27). The voltage is approx. +24VDC.
Y N
Replace the Booklet PWB (PL
Replace the Finisher PWB (PL 23.16).
Select Stop. Select [013-142 Rear Staple Home Switch] Select Start. Actuate the Rear Staple
Home Switch. The display changes.
Y N
Check the connections of P/J8895,
J8995 are connected correctly.
Y N
Connect P/J8895, P/J8893 and P/J8995.
Check the wire between J8895 and J8995 for an open circuit or a short circuit (BSD
12.27). The wire between J8895 and J8995 is conducting without an open circuit or
a short circuit.
Y N
Repair the open circuit or short circuit.
Measure the voltage between the Booklet PWB P8995-12 (+) and GND (-) (BSD 12.27).
The voltage is approx. +5VDC.
Y N
Replace the Booklet PWB (PL
Replace the Finisher PWB (PL 23.16).
Select Stop. If the problem continues, replace the Finisher PWB
Launch Version
WorkCentre 5225, 5230
P/J8893 and P/J8995. P/J8895, P/J8893
23.21).
P/J8893 and P/J8995. P/J8895, P/J8893
23.21).
(PL 23.16).

012-269 Booklet Sub-CPU Communications Fail

Communications between the Finisher PWB and the Booklet PWB Failed
Initial Actions
• Check the connectors at the Finisher PWB and the Booklet PWB are connected or seated
properly
• Check the wiring between the Finisher PWB and the Booklet PWB for damage
Procedure
Power OFF and Power ON the Printer.
The problem is resolved.
and P/
Y N
Reload the Software. The problem is resolved.
Y N
Replace the Finisher PWB
PWB (PL 23.21).
Rerun the job.
Rerun the job.
and P/
February, 2008
2-137
(PL 23.16). If the problem continues, replace the Booklet
Status Indicator Raps
012-268, 012-269