Rep 22.9.2 Set Clamp Shaft - Xerox WorkCentre 5222 Service Manual

12. Remove the rear Screw. (Figure 6)
(1)Remove the rear Screw.
Figure 6 Removing the rear Screw (j0fa42270)
13. Remove the Compile Assembly. (Figure
(1)Remove Compile Assembly.
Figure 7 Removing the Compile Assembly (j0fa42271)
Replacement
1. Reverse the removal procedure for replacement.
Repairs and Adjustments
REP 22.9.1, REP 22.9.2
7)

REP 22.9.2 Set Clamp Shaft

Parts List on PL 22.9
Removal
To avoid personal injury or shock, do not perform repair or adjustment with electrical
power applied to the machine.
1. Remove the A-Finisher from the machine.
2. Remove the Compile Assembly.
3. Remove the Bracket Assembly.
(1)Release Clamps (2) and remove the wire.
(2)Remove Screws (2).
(3)Remove Bracket Assembly.
Figure 1 Removing the Bracket Assembly (j0fa42272)
February, 2008
4-206
WARNING
(REP 22.1)
(REP 22.9.1)
(Figure 1)
WorkCentre 5225, 5230
Launch Version