Table of Contents
Advertisement
Mounting
5.1
Installation
NOTICE
Temperature-sensitive parts
Some parts of the motor enclosure can reach temperatures that exceed 100 °C.
Temperature-sensitive components, e.g. cables etc., can be damaged if they come into
direct contact with the motor enclosure.
When locating temperature-sensitive components, ensure that they do not come into
contact with the motor enclosure.
NOTICE
Shaft end
When installing the motor, ensure that the end of the shaft is protected against blows and
pressure.
Note
Observe the technical data on the motor enclosure rating plates.
The following must be taken into account when the motors are installed
● Observe the data on the rating plate, as well as the warning and information plates on the
● The permissible cantilever and axial forces at the shaft end of the motors may not be
Table 5- 1
Radial force
Axial force (both directions)
● Check that they match the conditions (temperature, installation altitude) at the installation
● Ensure that the end of the shaft is completely free of any anti-corrosion protection (use a
● Ensure that the flange is in even contact with the mounting surface. When tightening the
SIMOTICS A-1FV5/1PV5 synchronous/induction motors
Operating Instructions, 03/2014, 610.45002.40
motor.
exceeded.
Permissible forces at the motor
location.
commercially available solvent).
fixing screws avoid any uneven stressing. Observe the tightening torques for the fixing
screws of the motor flange (see Fixing (Page 30) Table 5.2).
1PV513x/1FV513x
1100 N
700 N
1FV516x
1800 N
1100 N
5
29
Advertisement
Table of Contents
