BMW X3 2018 Owner's Manual page 127

Secure the vehicle against rolling away, for in‐
stance with a wheel chock, after existing the ve‐
hicle.
After a power failure
To reestablish parking brake functionality after a
power failure:
1. Switch on standby state.
2. Pull the switch while stepping on the
brake pedal or selector lever position P is set
and then push.
This process may take a few seconds. Any
sounds associated with this are normal.
The indicator light is no longer illumi‐
nated as soon as the parking brake is
ready for operation again.
Turn signal, high beams,
headlight flasher
Turn signal
Turn signal in exterior mirror
When driving and during operation of the turn
signals or hazard warning system, do not fold in
the exterior mirrors, so that the signal lights on
the exterior mirror are easy to see.
Using turn signals
Press the lever past the resistance point.
Online Edition for Part no. 01402989843 - II/18
Driving
Triple turn signal activation
Lightly tap the lever up or down.
The triple turn signal duration can be adjusted.
Via iDrive:
1. "My Vehicle"
2. "Vehicle settings"
3. "Lighting"
4. "Exterior lighting"
5. "One-touch turn signal"
6. Select the desired setting.
The setting is stored for the driver profile cur‐
rently used.
Signaling briefly
Press the lever to the resistance point and hold it
there for as long as you want the turn signal to
flash.
High beams, headlight flasher
Push the lever forward or pull it backward.
▷ High beams on, arrow 1.
▷ High beams off/headlight flasher, arrow 2.
Washer/wiper system
General information
Do not use the wipers if the windshield is dry, as
this may damage the wiper blades or cause them
to become worn more quickly.
CONTROLS
127