BMW X3 2018 Owner's Manual page 100

CONTROLS
position. The sun protection
does not move.
▷ The tilted glass sunroof closes.
Opening/closing the glass
sunroof and sun protection
separately
▷ Press the switch in the desired
direction to the resistance
point and hold it there.
Holding down the switch
opens the sun protection. If
the sun protection is already
fully open, the glass sunroof
opens.
The glass sunroof closes
while the switch is being held.
If the glass sunroof is already
closed or in the tilted position,
the sun protection closes.
▷ Press the switch in the desired direction past
the resistance point.
The sun protection opens automatically. If the
sun protection is already fully open, the glass
sunroof opens automatically.
The glass sunroof closes automatically. If the
glass sunroof is already closed or in the tilted
position, the sun protection closes automati‐
cally.
Pressing the switch upward stops the motion.
Opening/closing the glass
sunroof and sun protection
together
Briefly press the switch twice in
succession in the desired direc‐
tion past the resistance point.
The glass sunroof and sun pro‐
tection move together. Pressing
the switch upward stops the motion.
100
Opening and closing
Online Edition for Part no. 01402989843 - II/18
Convenient opening via the remote control, refer
to page 79.
Closing via Comfort Access, refer to page 87.
Comfort position
In some models, the wind noises in the car's in‐
terior are lowest when the glass sunroof is not
fully open. In these models, the automatic func‐
tion initially only opens the glass sunroof up to
this comfort position.
Pressing the switch again opens the glass sun‐
roof fully.
Jam protection system
General information
If the closing force exceeds a certain value when
closing the glass sunroof, the closing operation is
interrupted once the roof reaches the half-open
position, or it is stopped when closing from the
tilted position.
The glass sunroof opens slightly.
Closing from the open position
without jam protection
If there is an external danger, proceed as follows:
1. Push the switch forward past the resistance
point and hold.
The glass sunroof closes with limited jam
protection. If the closing force exceeds a spe‐
cific threshold, closing is interrupted.
2. Push the switch forward again past the resist‐
ance point and hold until the glass sunroof
closes without jam protection. Make sure that
the closing area is clear.