Flushing - Graco Reactor E-10hp Instructions Manual

Flushing

Flushing
To avoid fire and explosion, always ground equipment
and waste container. To avoid static sparking and
injury from splashing, always flush at the lowest
possible pressure. Hot solvent may ignite. To avoid
fire and explosion:
• Flush equipment only in a well-ventilated area
• Ensure main power is off and heater is cool before
flushing
• Do not turn on heater until fluid lines are clear of
solvent
• Flush if you will be shut down for more than 3 days.
Flush more often if material is moisture sensitive
and humidity is high in the storage area, or if
material may separate or settle out over time.
• For long term storage, flush out the solvent with a
storage fluid or, at minimum, clean motor oil
• Flush with a fluid that is compatible with the fluid
being dispensed and the equipment wetted parts.
• Always leave some type of fluid in system. Do not
use water.
1. Engage piston safety lock or trigger safety lock.
Close fluid valves ISO and RES. Leave air on.
Fusion
2. Set function knob to Stop/Park
2
1
0
+
-
3. Shut off Heater Power. Allow system to cool.
26
Probler
.
3
4
5
6
7
8
9
10
ti21490a
4. Remove recirculation tubes (P) from supply tanks
and place in original containers or waste containers.
5. Turn Recirc/Spray valves to Recirc.
6. Set function knob to Fast Recirc
material from supply tanks until no more comes out.
1
0
+
-
7. Set function knob to Stop/Park
STATUS
1
0
+
-
8. Wipe out any remaining material from the supply
tanks. Fill each supply tank with 1-2 gal. (3.8-7.6 l)
of solvent recommended by your material
manufacturer.
9. Set function knob to Fast Recirc
through system to waste containers.
2
1
0
+
-
P
ti21488a
ti21495a
. Pump
2
3
4
5
6
7
8
9
ti31496a
10
.
2 3
4
5
6
7
8
9
10
ti21490a
. Pump solvent
3
4
5
6
7
8
9
ti31496a
10
332144H