The Output Page; Maxdepth; Pan And Pan2 - Kurzweil Flash Play PC4 Musician's Manual

Program Edit Mode

The OUTPUT Page

MaxDepth

Use the MaxDepth parameter to set the maximum modulation depth of Source 2.
When a DptCtl control source is at its maximum value, Source 2 will apply the amount of
modulation set by the MaxDepth parameter.
The OUTPUT Page
Use the Output page to adjust the left/right panning position and other panning settings
for each layer. The Output page also contains parameters for remapping the notes of drum
programs.
To control panning for all layers at once, use the Out Pan parameter on the Program Edit
Common page.

Pan and Pan2

Use the Pan parameter to adjust the panning of the current layer's pre-FX signal. Negative
values pan the signal to the left channel, positive values pan to the right, and a value of zero
pans to the center.
When the Keymap page has the Stereo parameter set to On, the Pan2 parameter appears on
the Output page. Use the Pan parameter to adjust the panning of the current layer's pre-FX
signal for the left keymap (Keymap 1), and use the Pan2 parameter to adjust the panning of
the current layer's pre-FX signal for the right keymap (Keymap 2).
3-57