Pressure Lfo->Pitch; Modwheel Lfo->Amp - Kurzweil Flash Play PC4 Musician's Manual

The Modwheel LFO->Pitch parameter works in combination with the Pitch Mod Sensitivity
parameter. To apply pitch modulation the Pitch Mod Sensitivity parameter and Modwheel
LFO->Pitch parameter must both be set to a value greater than 0.
To use a physical controller other than the Modwheel, go to the Parameters page, select the
FM Mod parameter, then select a different physical controller using the Control column.
Pressure LFO->Pitch
The Pressure LFO->Pitch parameter allows you to use keyboard pressure (aftertouch) to
control the pitch modulation depth of the FM LFO for all FM Operators in the layer.
When keyboard pressure is at its minimum value, pitch modulation depth is determined by
the Pitch Mod Depth parameter. When keyboard pressure is at its maximum value, pitch
modulation depth equals the value of the Pitch Mod Depth parameter plus the value of the
Pressure LFO->Pitch parameter.
Pressure values between the minimum and maximum will scale the amount of modulation
between the value of the Pitch Mod Depth parameter and the value of the Pitch Mod Depth
parameter plus the value of the Pressure LFO->Pitch parameter.
Pressure LFO->Pitch can be set to values from 0-99, where 0 applies no pitch modulation, 1
applies the least pitch modulation, and 99 applies the most pitch modulation.
The Pressure LFO->Pitch parameter works in combination with the Pitch Mod Sensitivity
parameter. To apply pitch modulation the Pitch Mod Sensitivity parameter and Pressure
LFO->Pitch parameter must both be set to a value greater than 0.
Modwheel LFO->Amp
The Modwheel LFO->Amp parameter allows you to use the Modwheel or other physical
controller to control the amplitude modulation depth of the FM LFO for all FM Operators
in the layer.
When the Modwheel is set to its minimum value, amplitude modulation depth is
determined by the Amp Mod Depth parameter. When the Modwheel is set to its maximum
value, amplitude modulation depth equals the value of the Amp Mod Depth parameter plus
the value of the Modwheel LFO->Amp parameter.
Modwheel values between the minimum and maximum will scale the amount of modulation
between the value of the Amp Mod Depth parameter and the value of the Amp Mod Depth
parameter plus the value of the Modwheel LFO->Amp parameter.
Modwheel LFO->Amp can be set to values from 0-99, where 0 applies no amplitude
modulation, 1 applies the least amplitude modulation, and 99 applies the most amplitude
modulation.
Program Edit Mode
FM Layer Page
3-93