The Keep Soft Button; The Done Soft Button - Kurzweil Flash Play PC4 Musician's Manual

Song Mode
The MIXER Page
Out
Use the Out parameter to set the rear panel audio outputs (A or B) used for each track of the
current song. This parameter determines the output settings for the main program signal and
insert effects of each track (for Aux effects output settings, use the Output parameters on the
Song Mode FX page.)
A setting of Auto will make that track output audio based on the settings for the program
used by that track. Program output settings are set in the Program Editor using the Output
parameters on the FX page or Layer FX page (see

The KEEP Soft Button

Press the KEEP soft button to view the Keep dialog, which allows you to capture the current
values for each track's program, panning, and volume as the initial values. After using the
Keep dialog, remember to save the song if you want these changes to be permanent.
If you don't use the Keep dialog, tracks will not have initial program, panning, and volume
values unless they are manually set for each track. See the Vol, Pan, Prog section above for
details on manually setting initial values for each track.
Note: Don't use the KEEP soft button if you would like certain tracks to not be stored with
initial values. In this case, only set initial values for each desired parameter as described in
"Setting Initial Volume Per

The DONE Soft Button

Press the DONE soft button to return to the song MAIN page.
8-16
"Output" on page 3-14
Track".
for details).