Output Section - Kurzweil K2600 - MUSICIANS GUIDE REV A PART NUMBER 910330 CHAP 15 Manual

Advanced KDFX

Output Section

Output Section
Insert
FXBuses
Figure 15-8
In the Output section, the various signal paths are routed to the K2600Õs physical outputs. Each
of the four output pairs, A, B, C, and D, has a selector switch to determine which signal it will
carry. All signals are stereo. The choices are:
Off
PreFXn
FXBusn The direct output, post-FX preset, from any of the four insert FXBuses.
Mix
AuxFX
There are no restrictions on the settings. If you like, all four outputs can be carrying the same
signal: PreFX1, for example.
15-18
FXBus1
Pre FXBus1
Off
Physical outputs
A
Physical
Output A
FXBuses and Physical Outputs
No output.
The signal coming into the FX preset on FXBus1, 2, 3, or 4. All of the EQs and
pan/width/balance settings of the input modules that are assigned to FXBusn are
active on this signal path, but the FX preset is not.
The signal from the Mix output, which can include the sum of any or all of the insert
FXBuses, and/or the Aux bus. The Level and Balance parameters on this page control
this output.
The outputs of the Aux bus.
Aux
effect
Mixer
Mix
Aux
Output B Output C
Output D