Src2; Dptctl; Mindpt; Output/Misc Parameters - Kurzweil Flash Play PC4 Musician's Manual

Program Edit Mode
FM Amp + Output Page

Src2

Use the Src2 parameter to modulate the layer output level with a physical controller or other
control source.

DptCtl

Use the DptCtl parameter to modulate the Src2 modulation depth with a physical controller
or other control source.
When a DptCtl control source is at its minimum value, the Src2 modulation depth will be
set to the value of the MinDpt parameter.
When a DptCtl control source is at its maximum value, the Src2 modulation depth will be
set to the value of the MaxDpt parameter.
DptCtl control source values between the minimum and maximum will scale the Src2
modulation depth between the values of the MinDpt and MaxDpt parameters.

MinDpt

Use the MinDpt parameter to set the minimum modulation depth of Src2.
When a DptCtl control source is at its minimum value, Src2 will apply the amount of
modulation set by the MinDpt parameter.
MaxDpt
Use the MaxDpt parameter to set the maximum modulation depth of Src2.
When a DptCtl control source is at its maximum value, Src2 will apply the amount of
modulation set by the MaxDpt parameter.

Output/Misc Parameters

The right-hand column of the FM Amp + Output page shows Output/Misc parameters for
the layer. The Output/Misc parameters for FM layers behave the same as the parameters on
the VAST layer Output page. For details on these parameters see "The OUTPUT Page" on
page 3-57.
3-97