Power Supply (S8VK)
AC (L)
AC (N)
Refer to the UPS S8BA User's Manual (Cat. No. U702) for details.
Refer to 5-4-3 Wire the Power Connector on page 5-33 for wiring details.
4
Supply power to the Power Supply.
5
Press and hold the UPS power button until On appears on the UPS display.
6
Power ON the Box PC and then wait until the device drivers are successfully installed.
7
Configure the UPS using the UPS Settings Utility.
Refer to UPS Setting Utility Instruction Manual for S8BA/BU-2RWL for details.
8
Install the Power Attendant Lite Utility.
Refer to NY-series Operating Systems and Software Utilities Manual (Cat. No. W616) for Pow-
er Attendant Lite Utility details.
9
Configure the UPS using the Power Attendant Lite Utility.
Refer to NY-series Operating Systems and Software Utilities Manual (Cat. No. W616) for Pow-
er Attendant Lite Utility details.
10
Configure the Box PC to auto-start after power loss within the BIOS settings.
Refer to A-1 BIOS on page A-2 for BIOS details.
11
Simulate a power interruption and confirm a correct shutdown of the Box PC.
• Start the Box PC
• Start applications
• Create a power interruption
• Monitor the shutdown sequence and confirm a correct shutdown sequence
The UPS is connected and configured.
The Box PC will shut down properly in case of a power supply interruption and restart automatically
when the power is restored.
NY-series Industrial Box PC Hardware User's Manual (W553)
UPS (S8BA)
Input
24 VDC
0 VDC
24 VDC
Output
USB
USB
5 Installation
Industrial PC
5-49
5