Power On; Power On Using The Power Button; Power On Using The Power On/Off Input; Auto Power On - Omron Sysmac NYB-0 Series Hardware User Manual

6 Operating Procedures
6-1

Power ON

This section provides Power ON details.
6-1-1

Power ON Using the Power Button

Start condition: Power is supplied to the Box PC and the Box PC is OFF.
1
Press the power button and release within 1 second.
Refer to 3-3 Power Button on page 3-9 for the power button location.
The Box PC starts and the PWR LED will turn ON.
2
Wait until the PWR LED is ON and verify that the ERR LED is OFF.
The Box PC is ON and the Operating System, if installed, starts.
6-1-2

Power ON Using the Power ON/OFF Input

Start condition: Power is supplied to the Box PC and the Box PC is OFF.
1
Supply an input signal to pins 3 and 4 of the I/O connector.
The input signal must remain ON for a minimum of 60 ms and a maximum of 750 ms to be
correctly detected by the Box PC.
The Box PC starts and the PWR LED will turn ON.
2
Wait until the PWR LED is ON and verify that the ERR LED is OFF.
The Box PC is ON and the Operating System, if installed, starts.
Additional Information
• Refer to 4-2-2 I/O Connector Specifications on page 4-19 for connector specifications.
• Refer to 5-4-4 Wire the I/O Connector on page 5-36 for wiring details.
6-1-3

Auto Power ON

The Box PC can be configured to start up when power is supplied to the power connector.
The Power Loss Control BIOS setting controls this behavior.
Set the Power Loss Control setting to Turn ON to activate the Auto Power ON function.
Additional Information
Refer to A-1 BIOS on page A-2 for BIOS details.
6-2
NY-series Industrial Box PC Hardware User's Manual (W553)