Parameter List Of The Technician Level - DURKOPP ADLER 577 Series Manual

11.3 Parameter list of the technician level ( accessible via the technician code "1907" )
Parameter Denomination
F - 100 Softstart-Stitch number
F - 111n2 Upper limit of the setting sector of the maximum speed
F - 115n6 Softstart-speed
F - 170Sr1 Setting the reference position
Position 0:
Thread take up lever short before the upper dead point,
Introduce the pin into the groove of the arm shaft!
F - 173Sr4 Checking the signal outputs and inputs by the
Variocontrol V810
01 = Sewing basket down ( ST2/34 )
02 = Sewing basket up ( ST2/35 )
03 = Knife ( ST2/37 )
04 = Sewing cycle ( ST2/27 )
05 = Needle cooling ( ST2/28 )
06 = Machine runs ( ST2/26, B4/6 )
07 = LED remnant thread monitor on the right ( ST2/25 )
08 = LED remnant thread monitor on the left ( ST2/23 )
By operating the switches connected to the control their
function will be checked and the display will present "on
/ oFF".
F - 179 Displaying the programme number of the control unit
with index and ID number.
The date will be presented in succession by pressing the
key Key B.
F - 195 Hook thread monitor
0 = Hook thread monitor Off
1 = Optical hook thread monitor;
Sewing basket down after counting
2 = Optical hook thread monitor;
Sewing basket up after counting
3 = Function like Setting 1
4 = Monitoring the hook thread by counting the
buttonholes
( Number of buttonholes according to the
setting of the parameter "F - 085"
46
Change over to the technician level
–
Turn off main switch.
–
Hold the key "P" on the control panel pressed down and turn on
the main switch.
–
Release the key "P" and enter the code number "1907".
( See the Operating Instructions of the motor manufacturer. )
–
Press key "E".
The control will change over to the technician level,
The parameter "F - 100" will be displayed.
Setting
max min Standard
254 0 1
5000 n2_ 4000
2500 70 1300
0