Changing The Parameter Values In The “Technician Level” And The “Manufacturer Level&#X94 - DURKOPP ADLER 867 Instruction Manual

9.2.4

Changing the parameter values in the “technician level” and the “manufacturer level”

All manuals and user guides at all-guides.com
CAUTION!
Since the machine can be damaged by a wrongly set sewing-drive
control, the changes of the parameter values have to be carried
out with greatest care!
Hint!
By performing a master reset, all parameter values can be reset to the
preset values See chapter 9 2 7
Entering the code number for the technician level with the
sewing-drive control DA32 G
–
Switch off the main switch
–
Actuate key “
–
Switch on the main switch
–
Release the key “
–
Actuate the key “
blinks
–
Enter code no
the blinking digit is altered
digit
–
Actuate the key “
.0.0.
“ ” is displayed
Selecting the parameter and changing of the values
–
Select the desired parameter by using the keys “
(see chapter 9 2 1 1 and 9 2 1 2)
–
Actuate the key “
–
By actuating the keys “
–
Actuate the key “
P
key “ ” - the same parameter is displayed
Memorizing altered parameter values
–
Actuate the key “
–
Sew a complete seam, that is push the pedal forward and then all
the way back and the changes are memorized
–
If no seam is started the changes will be lost
–
By actuating the key “
level
P
” and keep it pressed
On the display appears “
P
”
>>
” On the display appears “
90
By actuating the “
With the “>>” key you switch to the next
E
” The first parameter in the technician level
E
” The value of the parameter is displayed
+ -
” or “ ” the parameter value can be altered
E
” The next parameter is displayed or actuate the
P
”, the programming is ended
P
” again, you get back to the programming
cod
”
0
00" The left digit
+ -
” or “ ” keys, the value of
+ - >>
”, “ ” and “
*
”
51