DURKOPP ADLER 577 Series Manual page 145

–
Press the key Taste B.
The display will show "Pos 0 together with a circular symbol.
–
Turn the handwheel in the direction of rotation ( see the arrow on
the belt guad ) until the displayed symbol disappears and he
position Position 0 ( reference position ) is reached.
–
Press the key "E".
The reference positin will be accepted and the display will show
the parameter - 171".
–
Repeat the setting process ( Parameter "F - 170" ), if
the reference position has not been memorisd and the display
shows the error message "in A3".
Quit the correction mode
–
Press the key "P" two times.
The sewing basket will be lifted.
Memorise the setting
–
Lower the pedal forwards and release a complete sewing cycle.
The control will memorise he new setting.
Control the setting
–
When turning back via the Position 0 (reference position ), it is
necessary to lower the sewing basket ( see the Service
Instructions ).
NOTE !
The setting will be lost if no complete sewing cycle has been
performed before switching off the main switch!
2
15