Removal And Installation (Rp-1200); Storage - Echo TM-2000 Technical Manual

5) Remove the battery fastener nuts, washers,
battery fastener, and battery.
1
2
3
1 – Nuts, washers
2 – Battery fastener
3 – Battery
Installation:
1) Place the new battery in the robot.
2) Assemble the battery fastener, washers, and
nuts.
3) Connect the battery cable to the battery.
4) Place the cover on the robot.
5) Assemble the cover screws and washers. Tighten
screws to 5 lbf• ft (7 N•m).
6) Stand the robot on end.
7) Re-connect the two electrical cables.
8) Lay the robot back onto flat ground.
9) Complete the Charge Service Test.
11.4 Removal and Installation
(RP-1200)
PINCH AND CUT HAZARD
Allowing the rear panel and battery to drop freely
can pinch or cut fingers and hands.
• Hold the rear panel when removing the rear
panel retention screws. Slowly lower the rear
panel and battery after removing the screws.
Removal:
1) Remove the rear panel retention screws (3X).
2) Slowly open the rear panel and allow it to rest on
the ground.
3) Disconnect the battery cable from the battery.
4) Remove the battery bracket nuts (3X), and the
battery bracket.
5) Remove the battery.
Installation:
1) Place the new battery onto the rear panel.
2) Assemble the battery bracket over the battery.
3) Assemble battery bracket nuts (3X).
4) Connect the battery cable to the battery.
5) Close the rear panel.
6) Assemble the rear panel screws (3X).
7) Complete the Charge Service Test.

11.5 Storage

Prior to storage:
• Move the robot to the charging station, allow the
battery to completely charge.
• Move the main power switch for the robot to the
OFF position.
• Disconnect the battery cable from the battery.
B S I
ATTERY ERVICE AND NSTALLATION
R I (RP-1200)
EMOVAL AND NSTALLATION
69