Cutting Height System; Cutting Heads; Winter Storage; Chapter: 9 Service Procedures - Echo TM-2000 Technical Manual

S P
ERVICE ROCEDURES
C H S
UTTING EIGHT YSTEM

8.10 Cutting Height System

Clean the cutting height system once per week. Rotate
the lifting axle by hand and verify that the cutting heads
move up and down smoothly.
1
1 – Lifting axle

8.11 Cutting Heads

SHARP BLADES
Contact with cutting blades can result in cutting of
fingers or hands.
• Wear protective gloves when handling the ro-
bot.
Clean the cutting head assemblies once per week.
Verify that the cutting head assemblies move smoothly
up and down and the cutting discs and anti-friction
discs rotate freely. The cutting head should not have an
excessive amount of lateral movement.
1
1 1
1 1
1 – Cutting head assembly (5X)
2 – Cutting disc (one per cutting head assembly)
58
2

8.12 Winter Storage

• Charge the battery to 100% before storing.
• Complete all weekly, 6 month, and annual main-
tenance procedures.
• Schedule service procedures with an authorized
ECHO Robotics dealer (if required).
• Store the robot in a protected dry location where
the temperature is above 32° F (0° C).
At the start of a new season:
1) Move the power switch to the ON position.
2) Place the robot onto the charging station and
allow the battery to fully charge.
3) Run the robot as normal and observe for correct
operation.
9 Service Procedures
SHARP BLADES
Contact with cutting blades can result in cutting of
fingers or hands.
• Wear protective gloves when handling the ro-
bot.
Follow all Safety and Information Symbols
Only use an authorized ECHO Robotics dealer for
service procedures.
Genuine ECHO Robotics parts and assemblies for ECHO
Robotics products are available only from an autho-
rized ECHO Robotics dealer. Always supply a model and
serial number when purchasing parts and assemblies.
Move the power switch to the OFF position before
starting any service procedures.
on the robot.