Product Description; Unpacking - Parker 406LXR Series Product Manual

406LXR Series Product Manual

Product Description

406LXR Positioner
The 406LXR is a slotless, brushless linear servo motor positioner with square rail bearings housed
within a high strength, extruded aluminum body with magnetically retained protective seals. The
positioner is powered by a single row of high energy rare earth magnets. Advanced structural design
provides high load and moment capacity, dynamic stiffness and precise straightness and flatness of
travel, while minimizing total system weight. The positioner's integral linear encoder provides high
precision, non-contact positional feedback with selectable resolutions from 0.1 to 5.0 microns. The
positioner is also offered with hall effect limit & home sensors, and a "Quick Connect", extended life,
cable transport system.

Unpacking

Unpacking
Carefully remove the positioner from the shipping container and inspect the unit for any evidence of
shipping damage. Report any damage immediately to your local authorized distributor. Please save
the shipping container for damage inspection or future transportation.
Incorrect handling of the positioner may adversely affect the performance of the unit in its application.
Please observe the following guidelines for handling and mounting of your new positioner.
Product may be heavy. Standard handling and lifting practices should be employed.
DO NOT allow the positioner to drop onto the mounting surface. Dropping the positioner can generate
impact loads that may result in flat spots on bearing surfaces or misalignment of drive components.
DO NOT drill holes into the positioner. Drilling holes into the positioner can generate particles and
machining forces that may effect the operation of the positioner. Parker will drill holes if necessary;
contact your local authorized distributor.
DO NOT subject the unit to impact loads such as hammering, riveting, etc. Impacts loads generated by
hammering or riveting may result in flat spots on bearing surfaces or misalignment of drive
components.
DO NOT lift the positioner by cables or cable management system. Lifting positioner by cables or
cable management system may effect electrical connections and/or cable management assembly.
The unit should be lifted by the base structure only.
DO NOT push on magnetically retained strip seals when removing positioner from shipping crate.
Damaging strip seals may create additional friction during travel and may jeopardize the ability of the
strip seals to protect the interior of the positioner.
DO NOT submerge positioner in liquids or expose to large amount of liquid spray.
DO NOT disassemble positioner. Unauthorized adjustments may alter the positioner's specifications
and void the product warranty.
2
Chapter 1 - Introduction
Parker Hannifin Corporation
EMN Automation - Parker
Irwin, Pennsylvania