Square Rail Bearing Lubrication; Cable Managment Module Replacment - Parker 406LXR Series Product Manual

406LXR Series Product Manual
6. Remount carriage end caps. Insure that the compression springs are present under the shoulder screws in
the carriage end caps. Due to springs screws will need to be pressed into holes to start thread engagement.

Square Rail Bearing Lubrication

See previous section on Internal Access for access
to interior of positioner.
Tools Requires:
Shell Alvania RL 2
Isopropyl Alcohol
Clean paper towels
Small brush
Lubrication Type:
Use Shell Alvania RL 2 pn# 003-3686-30, non-
EP, lithium soap thickened greases. This grease
also inhibited with additives that promote long
service life and provide excellent lubrication and
corrosion protection. Shell Alvania Grease RL 2
is readily pumpable in pressure grease
dispensing systems.
Lubricant Appearance:
Smooth-textured, amber colored.
Maintenance Frequency:
Square rail bearing blocks are lubricated at our
facility prior to shipment. For lubrication
inspection and supply intervals following
Cable Management Module Replacement
Tools Requires:
Replacement Cable Management Module
Hex keys: 2.5mm and 2mm
Ball nose hex key: 3mm
Replacement Cable Module Part Numbers
Travel Code Replacement
Part Number
T01 006-2415-01
T02 006-2415-02
T03 006-2415-03
T04 006-2415-04
T05 006-2415-05
Chapter 6 - Maintenance and Lubrication
shipment, apply grease every 1000 hours of
usage. The time period may change depending
on frequency of use and environment. Inspect
for contamination, chips, etc, and replenish
according to inspection results.
Lubricant Application:
Wipe the rails down the entire length with a
clean cloth. Apply lubrication on the rails
allowing a film of fresh grease to pass under the
wipers and into the recirculating bearings.
After bearings are relubricated, clean encoder
tape scale located on inside wall of table. Use
only isopropyl alcohol and a clean lint free cloth
or paper towel. Using a lint free cloth, wipe
down linear tape scale to remove and dirt or
grease.
Caution!
clean the encoder scale. Use of other
solvents will permanently damage the
encoder scale. Use only isopropyl alcohol.
Note: Do not use/mix petroleum base grease with
synthetic base grease at any time. For lubrication
under special conditions consult factory.
Travel Code Replacement
Part Number
T06 006-2415-06
T07 006-2415-07
T08 006-2415-08
T09 006-2415-09
T10 006-2415-10
47
DO NOT use and other solvent to
Travel Code Replacement
Part Number
T11 006-2415-11
T12 006-2415-12
T13 006-2415-13
T14 006-2415-14
Parker Hannifin Corporation
EMN Automation - Parker
Irwin, Pennsylvania