Parker 406LXR Series Product Manual page 53

406LXR Series Product Manual
5. Slide the carriage all the way to the end of travel
on the connector block end. This will provide the
most cable carrier "slack" for removal of the
carriage connector.
Slide the connector block off the end of the base.
6. Pull the carriage connector straight away from the
carriage. Then lift the cable carrier up out of the
cable carrier supports.
Chapter 6 - Maintenance and Lubrication
Cable Module Reassembly
1. With the carriage moved to the end of travel on the
connector panel end. Place the cable carrier into
the carrier supports with the connector panel slid
off the end of the table.
2. Slide the carriage connector straight onto the
carriage using the mounting holes as an alignment
guide. Fasten with two (2) flat head screws
removed earlier.
3. Align the square nuts and slide the connector
panel into the T-slot on the base.
49
Parker Hannifin Corporation
EMN Automation - Parker
Irwin, Pennsylvania