Cabling - Parker 406LXR Series Product Manual

406LXR Series Product Manual

Cabling

The 406LXR is available with two (2) types of cabling:
Cable Transport Module
•
This is a complete cable management system including high flex cable (life rating of 10 million
cycles, dependent on motion cycle speeds, acceleration and environmental condition), cable
carriers, and connector system. This has been engineered for high life, maintenance free
operation. Extension cables are used to connect the table connector block to the amplifier and
controller. Refer to cabling diagrams for pin-out and wire color information.
•
The Cable transport module is replaceable. For detailed instructions on cable module removal
and installation please see Chapter 6 - Maintenance and Lubrication refer to the section Titled
Cable Management Module Replacement.
Un-harnessed OEM Cable System
•
This option provides high flex round cables directly from the carriage. This option is provided for
applications where the design of the machine already has a cable management system. Five
cables come from the carriage connector: motor, encoder, Hall effect, limit/home and auxiliary
cables.
•
Recommended bend radius for these cables is 100mm. This radius will provide 10 million cycles
of the cable. Smaller bend radius will reduce cable life while larger bend radius will increase life.
The un-harnessed OEM cable system can be replaced. Refer to Cable Management Module
Replacement in Chapter 6.
•
NOTE: The Cable Transport Module and the OEM Cable System are interchangeable in the
field. For detail please contact Parker Hannifin or your local Parker distributor.
Chapter 3 - Setup and Usage
25
Parker Hannifin Corporation
EMN Automation - Parker
Irwin, Pennsylvania