Outline Of The Settings Section - Konica Minolta CA-100Plus Instruction Manual

Outline of the Settings Section

This section explains settings that must be made according to measurement method.
Available measurement methods and the settings that must be made are explained below.
<Measurement by Konica Minolta's Calibration Standard>
With this method, measurement is performed using Konica Minolta's calibration standard without calibration.
Even if you are setting the target color to the memory channel CH00, measurement must be performed as ex-
plained below.
It is not necessary to set/change the target color if you are not going to use the analog display function.
[Operating Procedure]
<Measurement
Preparation section>
Page 33
• To set an ID name
• To use the analog display function : "Setting an Analog Display Range" (Page 68) *3
<Measurement by User Calibration>
With this method, user calibration is performed and the obtained correction factor is used for measurement.
Since the target color is also set, the analog display section can show the deviation of the measured values from the
target color. User calibration must be performed in the following cases. (However, it is not possible to perform user
calibration using the memory channel CH00.)
• To correct variation of readings that occur due to the deviation of spectral sensitivity from the CIE 1931 color-
matching function
• To correct difference of readings between instruments when two or more instruments are used
• Correction of difference of readings between measuring probes when two or more probes are used
[Operating Procedure]
<Measurement
Preparation section>
Page 33
• Details of user calibration
• To change the target color after user calibration: "Setting/Changing the Target Color" (Page 61) *1
• To set an ID name
• To use the analog display function
When using only the digital
display function
When also using the analog
display function
<Settings section>
Setting/Changing
the Target Color *1
Page 61
: "Setting an ID Name" (Page 66) *2
<Settings section>
User Calibration
• White calibration
• Matrix calibration
Page 50
: "About User Calibration" (Page 50)
: "Setting an ID Name" (Page 66) *2
: "Setting an Analog Display Range" (Page 68) *3
<Measurement section>
Measurement
Page 75
<Measurement section>
Measurement
Page 75
46