Table of Contents
Advertisement
From the Measurement Preparation section
When performing measurement using Konica Minolta calibration stan-
dard
*1
<Setting/Changing the Target Color> Page 61
1. Setting/Changing the Target Color by Measurement Page 62
This method can be used for any memory channels.
3,5
1
HOLD LED
When the optional 4-Probe Expansion Board CA-B04 is used
1 Press the
key to display the menu se-
lection screen.
2 Press the
key to open the PROBE se-
lection screen.
3 Press the
key until the desired probe
no. appears.
4 Press the
key to confirm the selection.
Memory channel
CH01 EXT
[
1. Press the CH
and
desired memory channel.
2. Place the measuring probe with the display and
take measurement.
3. Press the HOLD key.
The HOLD LED will light up.
4. Press the
key.
5. Press the HOLD key. Measurement will start.
The HOLD LED will light off.
●To set an ID name
●To use the analog display function : *3 <Setting the Analog Display Range>
To the Measurement section
4
2
Probe no.
Ad P1
]
keys to select the
Page 75
118
2. Setting/Changing the Target Color by Entering Values
Page 64
This method can be used for memory channel CH00 only.
1
3
When the optional 4-Probe Expansion Board CA-B04 is used
1 Press the
lection screen.
2 Press the
lection screen.
3 Press the
no. appears.
4 Press the
Memory channel
CH00 EXT
[
1. Press the CH
2. Press the
key.
CH00 x
3127 3293
_
Cursor
3. Enter the target color (x, y, Lv).
Ten-key (
to
Key ............................... The cursor moves in
4. Press the
key.
: *2 <Setting an ID Name> Page 120
Page 120
2
4
key to display the menu se-
key to open the PROBE se-
key until the desired probe
key to confirm the selection.
Probe no.
Ad P1
]
and
keys to select CH00.
y
Lv P1
40.0
,
) ... Used to enter values.
the order
x → y → Lv → x.
Advertisement
Table of Contents
