Table of Contents
Advertisement
6
Cursor key (
) ..................................... • Used to switch from one option to another in the PROBE, SYNC,
7
ENTER key (
) ................................... • Used to confirm each setting/selection you have made.
8
White, Red, Green, .................................. • Used to set RGB emission characteristics of the display.
Blue keys (
1
Holding down the
for two seconds or more
(Whistling sound.)
2
Holding down the
for five seconds or more
(Bleeping sound. A whistling sound
is heard when the setting is saved.)
3
Holding down the MR key .................... When xyLv, T∆ ∆ ∆ ∆ ∆ uvLv or XYZ measurement mode is selected
for two to four seconds
(Bleeping sound.)
4
Holding down the MR key .................... The unit of luminance will be displayed. (cd/m
for four seconds or more
(Bleep sounds two seconds later and
then four seconds later.)
5
Holding down the REMOTE key ......... The mode will switch to CA-100 compatible mode and CA-200
for two seconds or more
when turning on the power
Measurement Speed, Number of Digits, and RS232C baud rate
screens, which are opened from the menu selection screen.
)
key ....................... Locks all the keys except for the 0-CAL key. Holding down this
key again for two seconds or more will unlock the keys.
key ....................... Stores the current settings (probe, SYNC, memory channel, measurement
mode) to the instrument. The settings will be effective when the power is
turned on next time.
Displays serial number of the probe in use at the time calibration to
a user selected reference was performed and the target color were
set. (Page 73)
When an analyzer mode is selected
Displays serial number of the probe in use at the time RGB emission
characteristics of the display and the target color (W) were set. (Page
73)
mode alternately. (Page 15)
18
18
2
or fL)
Advertisement
Table of Contents
