2.
Slide out the 1st and 2nd paper trays.
3.
Pass the connector [A] through the opening [B].
4.
Install the tray heater assembly [C] (
5.
Remove the 2nd paper lift motor [A] (
6.
Route the heater cable [B] as shown.
7.
Clamp the heater cable at [C] as shown.
8.
Connect the heater cable to the ac cable at [D].
1.17.3 TRAY HEATER (OPTIONAL PAPER TRAY UNIT)
Disconnect the copier power cord before you start this procedure.
1.
Remove the joint brackets [A] (
SM
x 1).
x 2,
x 1).
x 1 each).
1-61
Heaters
D017/D018/D019/D020