G4 Internal Switches; G4 Parameter Switches - Ricoh Aficio MP2550B Service Manual

Bit Switches
No
5 Not used
Reconstruction time for the first line in
6 receive mode
0: 6 s 1: 12 s
7 Not used
G3-2 Switch 0B- Not used (do not change the settings)
G3-2 Switch 0C- Not used (do not change the settings)
G3-2 Switch 0D - Not used (do not change the settings)
G3-2 Switch 0E - Not used (do not change the settings)
G3-2 Switch 0F - Not used (do not change the settings)

4.3.7 G4 INTERNAL SWITCHES

The G4 internal switches (SW00 to 1F) are displayed but do not change these settings.

4.3.8 G4 PARAMETER SWITCHES

The G4 parameter switches (SW00 to 0F) are displayed but do not change these settings.
D361
G3-2 Switch 0A (SP No. 1-106-011)
Function Comments
Try using a longer setting if error code
0-21 is frequent.
Do not change the settings.
When the sending terminal is controlled
by a computer, there may be a delay in
receiving page data after the local
machine accepts set-up data and sends
CFR. This is outside the T.30
recommendation. But, if this delay
occurs, set this bit to 1 to give the
sending machine more time to send data.
Refer to error code 0-20.
ITU-T T.30 recommendation: The first line
should come within 5 s of CFR.
Do not change the settings.
120 SM