Advertisement
Connection of probes (pH + ORP + water temperature)
Connection of the amperometric probe and flow detector
-
The
amperometric
probe must be a 4-20 mA,
two-wire model.
1 - Completely unscrew the strain relief bushing: be careful and do not let
the black, flexible seal fall.
2 - Pass the 3 cables through the screw and strain relief bushing
3 - Connect each pod according to the indicator under each terminal block
4 - Tighten using a 2.5 mm/0.5-0.6 Nm slotted screwdriver
5 - Securely re-tighten the strain relief bushing by hand
Only Pentair probes are compatible and guarantee proper functioning of
the device.
11
Advertisement
