Table of Contents
Advertisement
(Configure > Setup > Edit Setup> General > Batch))
Batch is a firmware option which can be activated from
The Batch function allows the user to segment portions of data for further analysis. Setting
up a batch requires information to identify and control batches of data. Batch data can also
be paused, for viewing, and resumed. A batch can be aborted at any time, if so this will not
register as a batch, a batch is only complete when it has been stopped.
In this menu the user can stipulate which items are required when setting up a new batch.
A marker will appear for each item activated on this menu and will be placed on a chart. For
more details on batch Markers, refer to
Toggle the batch menu options On or Off.
When the configuration is complete select the Finish button to Commit, Discard or Commit
Later. Select the Back button to return to the previous menu.
43-TV-25-35 GLO Iss.4 Dec 06 UK
A5E01001767-04
Batch Menu
• User ID Required - Tick to make this a requirement when starting a new batch. If Pass-
words are active on the recorder then the User ID page will be skipped for user entry
and will be automatically entered.
• Description Required - Tick to make this a requirement when starting a new batch
• Comment Required - Tick to make this a requirement when starting a new batch
• Lot Required - Tick to make this a requirement when starting a new batch
• Allow Direct Access - Allows use of a Barcode reader to make entries for all the
listed in this menu.
• User Defined Name - Set this to User Defined to specify your own batch fields to
rename the following: Batch Name, User ID, Description, Lot No. and Comment. The
new field names will appear in
starting a new batch.
Power up
"Batch Setup/Batch Control" on page 117.
"Batch Setup/Batch Control" on page 117
"Credits" on page
92.
items
for
97
Advertisement
Table of Contents
