York HIDS006B21S Service Manual page 36

TROUBLESHOOTING
(4) Self-Checking
Self-Checking checks the wired controller and clears EEPROM (storage cell inside of the wired
controller).
(1) Press and hold "Menu" and "ECO" simultaneously
for three seconds during the normal mode (when
unit is not operating).
The Check Menu is displayed.
(2) Select "Self Checking" from the Check Menu and
press "OK".
(3) Select the process for "Self Checking".
* To start self check, press "ECO".
* To clear EEPROM, press " " and "ECO"
simultaneously.
See EEPROM clear process (15) below.
(4) LCD Test
Press "OK" and the screen changes as shown at
the right.
(5) Backlight Test
LCD brightness is changed gradually by pressing
"OK".
(6) Contrast Test
Contrast of the LCD gradually changes by
pressing "OK".
(7) Run Indicator Test
Press "OK" and the run indicator flashes in red
and green twice for each.
(8) Button Input Test
Press the nine buttons one-by-one. The number
indicated with "
being pressed.
* The order of pressing buttons is random.
Do not press more than one button at a time.
They are not counted.
3-14
A " counts up as buttons are
Check Menu
I. U./O. U. PCB Check
Self Checking
Sel.
Self Checking
0 1 : 0 0 0
P-3400
ARF-8Y050 2008.11.06 12:34
Self Checking
0 2 : 0 0 0
03: Backlight Test
04: Contrast Test
05: Run Indicator Test
Self Checking
0 3 : 0 0 0
Self Checking
0 6 : 0 0 0
02
/
02
OK Entr Rtrn
Back
A
SM-18001-rev.1