Nortel Enterprise 1000 Reference Manual page 22

Page 22 of 236 Succession System Controller card
Table 2
Default SDI port settings on the NTDK20 SSC card
TTY Port
0
1
2
553-3023-211 Standard 1.00 June 2001
SDI ports
The NTDK20FA SSC card in both the Call Server and the Media Gateways
contains three SDI ports used to connect on-site terminals or remote terminals
through a modem. Table 2 on page 22 shows the port default settings.
Baud rate
Set by a DIP switch
1200
1200
Conferencing
Thirty-two conference channels are provided by the NTDK20FA SSC card's
conference devices. Conference capability can be increased by mounting
expansion daughterboards on the NTDK20FA SSC card. Each dual IP
daughterboard increases the total number of conference channels by 32: the
maximum number of conference ports is 96.
Each conference device provides 32 ports of conferencing capabilities (one
conference participant for each port). A conference call can have three to six
participants. For example, you can have a maximum of six 5-party
conferences for each device, or four 6-party conferences plus two 3-party
conferences. It is not possible to conference between conference devices.
10BaseT port
The Call Server provides one 10BaseT connection to a Local Area Network
(LAN) to interface with Management software applications such as OTM and
CallPilot. The Media Gateway SSC 10BaseT port is disabled by default. To
use the 10BaseT port, the port must be assigned a unique IP address and the
port must be enabled from the Call Server.
Data Stop
bits bits
8 1
8 1
8 1
Parity Use
None MTC/SCH/BUG
None MTC/SCH/BUG
None MTC/SCH/BUG