Siemens SINUMERIK 840D sl Commissioning Manual page 63

11/2006
9687
MD number
Standard value: 0
Change becomes effective after: POWER ON
Data type: BYTE
Significance:
9718
MD number
Standard value: 2
Change becomes effective after: IMMEDIATELY
Data type: LONG
Significance:
9719
MD number
Standard value: H5
Change becomes effective after: IMMEDIATELY
Data type: LONG
Significance:
9724
MD number
Standard value: 5000
Change becomes effective after: IMMEDIATELY
Data type: DOUBLE
Significance:
© Siemens AG 2006 All Rights Reserved
SINUMERIK 840D sl Commissioning Manual CNC: ShopTurn – 11/2006 Edition
$MM_CMM_TOOL_MOVE_DEFAULT_MAG
Reload tool in default magazine
Min. input limit: 0
Protection level: 3/4
This MD is used to stipulate the magazine in which ShopTurn first searches for an empty
location when reloading a tool.
$MM_CMM_OPTION_MASK_2
Settings for ShopTurn
Min. input limit: 0000
Protection level: 1
Bit 0: Do not jump to Automatic mode when an external program (from the PLC) is selected
for execution.
Bit 1: Influence simulation speed by feed override
Bit 2: Do not display the basic offset in the measuring and program mask and cannot be
entered.
Bit 3 to bit 6: Reserved
Bit 7: Deactivate the function approaching and departing along the software limit switches
for the swivel heads.
Bit 8: Reserved
Bit 13: The correction angle is inverted during boring (E_DR_BOR).
$MM_CMM_OPTION_MASK
Settings for ShopTurn
Min. input limit: 0000
Protection level: 1
Bits 0 to 8: Reserved
Bit 9: Start program execution in all screens.
Bit 10 to bit 17: Reserved
Bit 18: When switching from manual/MDI/Auto, change the operating mode but not the
ShopTurn user interface.
Bit 19: Instead of "MCS" and "WCS" display texts "Machine" and "Workpiece".
Bit 20: Display work offsets not as "ZO1", but as "G54" (except in the work offset list).
Bit 21: Enable basic record display.
Bit 22 to bit 25: Reserved
Bit 26: Enable directory "Part programs" in program manager.
Bit 27: Enable directory "Subroutines" in program manager.
Bit 28 to bit 30: Reserved
Bit 31: Always display coordinates system for G17 as follows: X to right, Y up (right–han-
ded coordinates system) or down (left–handed coordinates system).
$MM_CMM_CIRCLE_RAPID_FEED
Rapid feed for positioning on circular path
Min. input limit: 0
Protection level: 3/4
This MD is used to stipulate the rapid feed rate in mm/min for positioning on a circular path.
This applies for the functions "full circle"/"pitch circle" ("Drilling" menu → "Positions") and
"circumferential groove" ("Milling" menu → "Groove").
7.2 Display machine data for ShopTurn
Max. input limit: 30
Valid as of software version
ShopTurn 6.4
Max. input limit: FFFF
Valid as of software version
ShopTurn 7.1
Max. input limit: FFFF
Valid as of software version
ShopTurn 7.1
Max. input limit: 100000
Valid as of software version
ShopTurn 6.1
7 Machine Data
Units: –
Units: Hex
Units: Hex
Units: mm/min
7-63